For more use of driver parameters, please visit our github instructions:
When using, it needs to correspond to the pin sequence of the touch screen, do not reverse the connection, otherwise the touch screen may be damaged. The touch screen is equipped with adhesive paper that is attached to the e-paper. The adhesive film must be torn off when using it, and the display area on the corresponding e-paper is correctly pasted. Avoid tearing the adhesive tape repeatedly or it may damage the touch screen. Avoid pulling the touch screen cable when using it.
|-ESP32-WROVER-E (ESP32-D0WDQ6 V3)||-TYPE-C -PH 2.0 Holder|
|-16MB FLASH -PSRAM 8MB||-6pin FPC touch screen expansion connector|
|-USB to TTL CP2104||-Battery charge and discharge protection chip|
|-4.7 inches, 540(H)X960(V) resolution, 16 Gray Level ED047C1, and supports partial refresh.||-USB input power 5V@1A -Sleep mode current@~170uA|
|-960X540 resolution 8-bit parallel port 4.7 inch ink screen||-4pin expansion interface output is 3.3V|
|-4pin 2.0 molex 4 p 53015-0410 X3||-RST button X1 -Custom button X3|