Description:

Wiring:

Control terminal for SET:

1. The motor speed control wiring methods: available potentiometer system speed can also be connected to the MCU control, when the potentiometer control wiring, the potentiometer middle pin is connected to VR speed port, potentiometer connected to both ends of 5V and GND terminal voltage more high speed faster.

2. Motor steering control wiring methods: you can switch control can also be connected to the MCU control, to GND in one direction, then in one direction 5V.

Note: Due to different motor manufacturers to make the hall of hall line order does not necessarily follow the line on the board to match the sequence, need to be adjusted. Motor driver board 12-36V DC power input, VCC positive power supply,GND power supply is negative.

Tips:

If you use less than 60W, without additional heat sink , be sure to add more than 60W

heatsink fins drive efficiency without lowering the temperature is too high will shine into permanent damage! We recommend cooling surface area greater than 200 square centimeters! Proposes to add insulation films, both sides of the insulating sheet plus thermal grease!

Features:

• Operating voltage: DC 12V-36V
• Operating Current: <=15A
• Driver Power: <=500W
• Speed Voltage: 0.1V-5V
• Operating Temperature:-40-85°C
• Humidity: 90%RH
• Stall protection:Yes
• Enable Control: Yes
• Over-current protection: Yes
• Steering control: Yes
• Speed control signal: Yes
• Size: 63×42×17mm(L×W×H); Probe size 3mm, length: fixing hole center distance 57mm; width:fixed hole center distance 36.5mm